To Next PageTo Next Page
Need help?Do you have a question about the Siemens LMO24.111C2 and is the answer not in the manual?
General| Brand | Siemens |
|---|---|
| Model | LMO24.111C2 |
| Category | Control Unit |
| Language | English |
Describes the intended use of LMO burner controls for startup and supervision of oil burners.
Lists essential features like EN 267 compliance, monoblock design, and digital signal handling.
Critical warnings on unit modification, qualified staff, electrical isolation, and shock hazards.
Guidelines for proper mounting, installation, wiring, and compliance with electrical regulations.
Best practices for wiring flame detectors to ensure reliable signal transmission.
Safety checks for burner startup, detector function, and simulated flame loss.
Compliance with EEC directives, ISO standards, and EN 230 identification codes.
Proper use of service adapters KF8885, KF8833, KF8840 for burner control diagnostics.
Details the designed lifetime of burner controls in startup cycles and operational years.
Instructions for disposing of electronic components according to local legislation.
Describes the impact-proof housing and internal components like microcontroller and signal lamp.
Covers multicolor status indication and data transmission for diagnostics.
Compares LMO series types, voltage, capacity, reset, and LOA equivalents.
Lists oil burner controls, connection accessories, and flame detectors.
Details interface OC1400, PC software ACS400/ACS410, and demo cases.
Information on test adapters KF8885/KF8833/KF8840 and lockout reset button extensions.
Provides mains voltage, frequency, power consumption, weight, and safety class.
Specifies storage, transport, and operation conditions for temperature and humidity.
Lists permissible currents for terminals and maximum cable lengths for detectors.
Details detector current requirements and permissible values for QRB and QRC detectors.
Explains the meaning of green LED status indications for flame signal stability.
Illustrates the measurement circuit for detector current using QRB and QRC detectors.
Lists conditions like reset, closed contacts, and no undervoltage for burner startup.
Describes safety shutdown on low mains voltage and restart on voltage recovery.
Explains automatic shutdown after 24 hours and fault handling including lockout reset.
Details the maximum number of repetitions allowed for flame loss during operation.
Identifies the lockout reset button (EK) and multicolor signal lamp (LED) for operation and diagnostics.
Outlines visual diagnostics and interface diagnostics using OCI400/PC software.
Explains the color code table for the multicolor signal lamp indicating operating states.
How to activate visual diagnostics by pressing the lockout reset button for over 3 seconds.
Lists red blink codes for the signal lamp and corresponding possible causes of fault.
Procedure to quit fault diagnostics and restart the burner by resetting the control.
Provides internal diagram, connection diagram, and control sequence for LMO14 series.
Shows internal diagram, connection diagram, and control sequence for LMO24 series.
Details internal diagram, connection diagram, and control sequence for LMO44 series.
Defines abbreviations for components (AL, BV, EK, FS, etc.) and signals.
Explains symbols and notations used in the control sequence diagrams (A, B, C, D, timings).
Provides overall dimensions of the LMO burner control unit in millimeters.
Shows dimensions for the AGK11 plug-in base and AGK20 lockout reset button extensions.
