To Next PageTo Next Page
Need help?Do you have a question about the Siemens LOGO! 230RCo and is the answer not in the manual?
General| Digital Inputs | 8 |
|---|---|
| Programming Software | LOGO! Soft Comfort |
| Protection Class | IP20 |
| Type | Logic controller |
| Supply Voltage | 230 V AC |
| Digital Outputs | 4 |
| Communication Ports | Ethernet |
| Data Memory | 10 KB |
| Clock | Real-time clock |
| Display | Yes, LCD |
| Operating Temperature | 0°C to 55°C |
| Dimensions (W x H x D) | 72 x 90 x 55 mm |
Defines the meaning of hazard symbols and notices used in the manual.
Specifies that only authorized personnel should install and work on the equipment.
Provides general data including dimensions, weight, and environmental conditions.
Provides essential guidelines for safe and compliant installation and wiring.
Detailed instructions and guidelines for wiring the LOGO! device.
Explains how to connect sensors and devices to LOGO! inputs.
Details on connecting loads to LOGO! relay and transistor outputs.
Instructions for integrating LOGO!...B11 variants with the ASi bus.
Describes LOGO!'s behavior upon power on and resumption.
Step-by-step guide to entering and executing programs on LOGO!.
Describes the On Delay function, its parameters, and timing diagrams.
Describes the Off Delay function, its parameters, and timing diagrams.
Describes the On/Off Delay function, its parameters, and timing diagrams.
Describes the Retentive On Delay function, its parameters, and timing diagrams.
Describes the Latching Relay function, its parameters, and switching behavior.
Describes the Current Impulse Relay function, its parameters, and timing diagrams.
Describes the Interval Time-Delay Relay with Pulse Output function.
Describes the Edge-Triggered Interval Time-Delay Relay function.
Describes the Seven-Day Time Switch function and its parameterization.
Describes the Twelve-Month Time Switch function and its parameterization.
Describes the Up/Down Counter function, its parameters, and timing.
Describes the Operating Hours Counter function and its parameters.
Describes the Symmetrical Clock Pulse Generator function and its parameters.
Describes the Asynchronous Pulse Generator function and its parameters.
Describes the Random Generator function and its parameters.
Describes the Frequency Trigger function and its parameters.
Describes the Analog Trigger function and its parameters.
Describes the Analog Comparator function and its parameters.
Describes the Stairwell Light Switch function and its parameters.
Describes the Dual-Function Switch function and its parameters.
Describes the Message Texts function and its limitations.
Detailed steps for modifying parameter values.
Step-by-step guide to copy programs from LOGO! to a program module.
Instructions for copying programs from modules back to LOGO!.
Explains how to establish a physical connection between LOGO! and a PC.
