The loudspeaker is glued to the upper housing section by a foam
covered with glue on both sides. When you remove it, the foam
will be damaged. Please use new loudspeaker for assembling
Upper Housing Assembly.
For assembly of a new Upper Housing install a new earphone first, watch out for the orientation.
For install of the other parts just reverse the sequence for the disassembly.
Assemble the M35
STEP 1:
Check that the Lower Housing Assembly, Control Board Assembly and Upper Housing
Assembly are in good order. Check if the Buzzer sealing was installed on the Control Board.
N e w U p p e r a n d L o w e r C a s i n g m u s t b e u s e d . A l l
c o n t a c t p i n s m u s t n o t b e d i r t y , d a m a g e d o r b e n t !
I f a n y p a r t i s n o t O . K p l e a s e r e p l a c e i t w i t h a
n e w p a r t .
PHOTO 2.23 ASSEMBLE M35i – STEP 1 PHOTO 2.24 ASSEMBLE M35i – STEP 2
STEP 2:
Place the Control Board Assembly in the Upper Housing as illustrated in PHOTO 2.24.
To Next Page
Loading...
