Siemens M55 - Calling; Dialling with number keys

Calling
24
M55 Barracuda fug am, A31008-H6300-A40-1-4A19 (20. May 2003, 16:01)
© Siemens AG 2001, I:\Mobil\L55\M55_Barracuda\am\M55\fug\M55_Phone.fm
Calling
Dialling with number
keys
The phone must be switched on
(standby mode).
J
Enter number (always
with area code, if
necessary with
international dialling
code).
§Clear§ A short press clears
the last digit, a long press
clears the entire phone
number.
A
Press the Call key. The
displayed phone number
is dialled.
End call
B
Press End key briefly. The
call is ended. Press this
key even if the person on
the other end of the line
has hung up first.
Set volume
E
Use the control key (top)
to start adjusting the
volume (only possible
during conversation).
G Set volume and confirm
with §OK§.
If a Car Kit is used, its volume setting
will not affect the usual setting on
the phone.
Redial previous numbers
To redial the phone number last
called:
A
Press Call key twice.
To redial other numbers that were
dialled previously:
A
Press the Call key once.
G
Pick out the required
phone number from the
list, then press ...
A ... to dial.
Additional information
 Save phone number in
Addressbook/Phonebook........p. 35, p. 38
§Options§ Call lists............................p. 43
§Hold ................................................p. 26
y menu§ Call menu.........................p. 28
§Forward§ Set divert .........................p. 78
§Speaker.§ Speakerphone ................p. 26
Microphone off ..................................p. 28
Voice dialling .....................................p. 41
Auto key lock .....................................p. 77
Phone number transmission off/on
(Hide ID)............................................p. 78
International dialling codes............. p. 118
Phone number memo......................p. 120
Control codes (DTMF).....................p. 115