Siemens M55 - Security

m Setup
84
M55 Barracuda fug am, A31008-H6300-A40-1-4A19 (20. May 2003, 16:01)
© Siemens AG 2001, I:\Mobil\L55\M55_Barracuda\am\M55\fug\M55_Setup.fm
Send vce/fax
Set this function on the phone before
transmission so that you can switch
from voice mode to fax mode.
While the connection is being set up,
the following function is available
for two seconds:
§Voice/fx§ Switch to Send vce/fax
mode; you may now send
a fax.
Voice/fax rec
(Only if no special fax or data number
is available).
Start the required communication
program on your PC and select the
function on the phone during the call
(the PC will take over the
connection).
End transmission
End transmission with PC-software
and/or press
B
.
Authentication
§Edit§ Activate encrypted WAP
dial-up (CHAP: Challenge
Authentication
Procedure) or deactivate
(PAP: Personal
Authentication
Procedure).
Security
§Menu§KmKSecurity
KSelect function
The phone and SIM card are
protected against misuse by several
security codes.
Codes
PIN control, Change PIN, Change PIN2,
Chg.phonecode, (p. 21).
Babysitter
(Phone-code protected)
Only one phone number can be
dialled. Hold down the right soft key
(p. 29).
Only ‚
(PIN 2 protected)
Dialling options are restricted to SIM-
protected phone numbers in the
Phonebook. If only area codes are
entered, relevant phone numbers
can be added to these manually
before dialling.
If the SIM card does not support PIN
2 input, the whole Phonebook can be
protected with the phone code.
L
L