Siemens M65 - Getting started; SIM card and battery

©
Siemens AG 2003, M:\Mobil\R65\M65_X-cite\am\fug\_von_itl\M65_Startup.fm
13Getting started
VAR Language: American; VAR issue date: 16-Februar-2004
left page (13) of M65 X-Cite FUG us, A31008-H7150-A40-1-4A19 (14.04.2004, 17:25)
Getting started
The phone must be assembled
before you can get started.
SIM card and battery
• Place the SIM card in front of the
slot with the contact surface fac-
ing downwards. Then slide the SIM
into the holder
1).
• Insert the battery sideways into
the phone
2
, then press it down-
wards
3
until it clicks into place.
Battery cover
• Pull the rubber gasket over the
locating lugs
1 on the cover, then
push it onto the four studs
2 so
that it is firmly positioned on the
cover.
• Push cover forwards
3 until the
locating lugs engage in the open-
ings in the phone.
Additional information
Your phone's display is supplied with a
protective film. Remove this film slowly
before assembling the phone. In rare
cases, static discharge may cause dis-
colouration at the edges of the display.
However this will disappear within approx.
10 minutes.