Siemens MCP 398C Diagnostics Guide

Overview of Alarms 08/2005
2-932
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Parameters: %1 = Axis
%2 = Fault code of drive (P824)
%3 = Fault value of drive (P826)
%4 = Fault time of drive (P948/P825)
Definitions: Contents of fault memory of assigned drive.
Reactions: - Alarm display.
Remedy: See drive documentation for fault codes/fault values.
Program Con-
tinuation:
Alarm display showing cause of alarm disappears. No further operator action necessary.
380501 PROFIBUS DP: fault on bus,slave %1, code %2, value %3, time %4
Parameters: %1 = 8 bit high = bus number 8 bit low = slave number
%2 = Fault code of drive (P947)
%3 = Fault value of the drive (P949)
%4 = Fault time of the drive (P948)
Definitions: Contents of the fault memory of the assigned slave.
Reactions: - Alarm display.
Remedy: See drive documentation for fault codes/fault values.
Program Con-
tinuation:
Alarm display showing cause of alarm disappears. No further operator action necessary.
380502 PROFIBUS DP: bus %1, slave %2 configuration changed
Parameters: %1 = Bus number
%2 = Slave address
Definitions: The PB bus configuration has changed.
Causes:
• Initial start-up
• New PB slave recognized on the bus
Reactions: - Interface signals are set.
- Alarm display.
Remedy: In order to operate the bus with the new configuration, an additional restart will be
required.
Program Con-
tinuation:
Switch control OFF - ON.
380503 PROFIBUS DP: bus %1 configuration changed
Parameters: %1 = Bus number
Definitions: A new SDB2000 with a modified configuration was provided.
The new settings will be activated only at the next ramp-up of PROFIBUS.
Reactions: - Interface signals are set.
- Alarm display.
Remedy: In order to operate the bus with the new configuration, an additional restart will be
required.
Program Con-
tinuation:
Switch control OFF - ON.
400102 Delete DB 2 in the PLC and restart
Definitions: The DB created by the basic program and the existing DB differ in size.
Reactions: - Alarm display.

Siemens MCP 398C Specifications

General

Brand	Siemens
Model	MCP 398C
Category	Control Systems
Language	English