08/2005 Overview of Alarms
2-943
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Program Con-
tinuation:
Internal
400264 Pointer parameter machine control panel 1 incorrect
Definitions: A pointer is incorrect in the MCP1 parameter range.
Reactions: - Alarm display.
Remedy: Correct the PLC configuration in the FB1 parameters.
Program Con-
tinuation:
Switch control OFF - ON.
400265 Pointer parameter machine control panel 2 incorrect
Definitions: A pointer is incorrect in the MCP 2 parameter range.
Reactions: - Alarm display.
Remedy: Correct the PLC configuration in the FB1 parameters.
Program Con-
tinuation:
Switch control OFF - ON.
400266 Pointer parameter handheld unit incorrect
Definitions: A pointer is incorrect in the HHU parameter range.
Reactions: - Alarm display.
Remedy: Correct the PLC configuration in the FB1 parameters.
Program Con-
tinuation:
Switch control OFF - ON.
400267 Access error
Definitions: MCP or HHU data could not be accessed
Reactions: - Alarm display.
Remedy: Check the MCP or HHU parameters of the FB1.
Program Con-
tinuation:
Switch control OFF - ON.
400604 Set change with M06 in the machine data
Definitions: With the magazine type used (box magazine, chain), changing is possible only with M06.
If necessary, also check for impermissible settings at revolver magazines.
Reactions: - Alarm display.
Remedy: Set the value in the channel-specific machine data TOOL_CHANGE_MODE (MD 22550)
to 1.
Program Con-
tinuation:
Internal
400902 Parameter ChanNo impermissible in FC 9
Definitions: The parameterized channel does not exist.
Reactions: - Alarm display.
Remedy: Correct the parameter.
Program Con-
tinuation:
Switch control OFF - ON.
400903 Parameter IntNo impermissible in FC 9
Definitions: The parameterized interrupt does not exist.
Reactions: - Alarm display.
Remedy: Correct the parameter.
To Next Page
Loading...
Need help?
General
