SINUMERIK 840D sl 2010-11-26
Upgrade Instructions
SINUMERIK Operate 2.6 SP1 HF3 for PCU 50.3
© Siemens AG 2010 Page 3 of 5
AP00941509 AP00951133 ST: Program sequences in the simulation are not synchronous
AP00951138 Simulation: Position shift of the traversing blocks
AP00951181 Operate with Simatic-CPU: Editor cannot be used
AP00952532
ST: Problems with simultaneously recording/simulation - position
circle is not symmetrical
AP00984687 AP00956955 Contour violation for simulation with less than 100% override
AP00941603 AP00957132
Under certain circumstances, the main spindle is started with a high
speed after a block search
AP00957622 Operate crashes when reading-in a DP archive
AP00964096 Problems with reading-in ASCII drive data
AP00964891
Commissioning: Under certain circumstances, device
commissioning is not completed
AP00964910 No axis identifiers on the softkeys for different configuration
AP00964956 Selection for JobShop program, no NC start after reset possible
AP00964963
ST: Under certain circumstances, the program header cannot be
transferred
AP00966363 Crash in the Editor when selecting marking and scrolling
AP00960336 AP00968332
For 2-channel workpiece in the simulation, no contour lines in
Channel 1
AP00968337
With end of program in channel 2, programs blocks are no longer
displayed in Channel 3
AP00968348 MDA buffer is not displayed after "Load MDA" in channel 2
AP00968353
After "Load MDA", the MDA buffer is not displayed in the single-
channel view
AP00968383
In spite of MD35010=1, the selection screen for the gear stage is
missing under TSM
AP00968385 NC/PLC: Customer's PLC symbols can no longer be linked in
AP00958899 AP00970298 Equipment data files cannot be opened under system data
AP00928470 AP00970311
Sporadic HMI crash without any meaningful information in the crash
log
AP00971136 AP00971536 Crashes in the simulation
AP00972642
Tool manager: Cancel write protection for $TC_TP_MAX_VELO and
$TC_TP_MAX_ACC
AP00973493
When importing an archive, the rights of the card/user/sinamics are
changed
AP00974378 AP00975018 Incorrect display in the simulation
AP00961083 AP00975024 Simulation, Start-Stop button for single block
AP00975562
Problems when importing NC archives as a result of incorrect
memory setting
AP00975575 Overstore responds incorrectly
AP00977307
EasyScreen: Code is incorrectly generated if the cycle name starts
with "N"
AP00977374 Simulation: Tailstock data missing
AP00979784 AP00980576 WO (work offset) fine for G521 is not correctly displayed
AP00981809 Device configuration sporadically stays where it is
AP00981611 AP00981811 HMI crash for longer operating times
AP00993643 AP00995056
Under certain circumstances, it takes a very long time for a DIN
program with block structure to open
AP00981965 AP00984191 Sporadic HMI crash
AP00988969 AP00991345 Axis gaps cause an incomplete display in the simulation
To Next Page
Loading...
Need help?
General
