3
..........................................................................................
CAUTION
• Do not allow children or the general public
to access or approach this equipment
• Do not install the inverter where it will be
subject to shock, vibration, electro-magnetic
radiation, water hazards, or atmospheric
pollutants such as dust or corrosive gases
• High voltage insulation test equipment must not
be used on cables connected to the Eco.
• Keep operating instructions within easy
reach and give them to all users
• Use this equipment only for the purpose
specified by the manufacturer. Do not carry
out any modifications, or fit any spare parts,
which are not sold or recommended by the
manufacturer; this could cause fires, electric
shock or other injuries.
EUROPEAN LOW VOLTAGE DIRECTIVE
The MICROMASTER Eco and MIDIMASTER Eco product range complies with the
requirements of the Low Voltage Directive 73/23/EEC as amended by Directive 93/68/EEC. The
units are certified for compliance with the following standards:
EN 60146-1-1
Semiconductor converters-
EN 60204-1
Safety of machinery-
General requirements and Electrical equipment
line commutated converters of machines
EUROPEAN MACHINERY DIRECTIVE
The MICROMASTER Eco and MIDIMASTER Eco product range do not fall under the scope of
the Machinery Directive. However, the products have been fully evaluated for compliance with
the essential Health & Safety requirements of the directive when used in a typical machine
application. A declaration of incorporation is available on request.
EUROPEAN EMC DIRECTIVE
When installed according to the recommendations described in this manual, the
MICROMASTER Eco and MIDIMASTER Eco product range fulfil the requirements of the EMC
Directive as defined by the EMC Product Standard for Power Drive Systems EN 61800-3
UL and CUL listed power conversion
equipment type 5B33 for use in pollution
degree 2 environment
ISO 9001
Siemens plc operates a quality management system which complies with the requirements of ISO
9001.