To Next PageTo Next Page
Need help?Do you have a question about the Siemens 6RA70 Series and is the answer not in the manual?
General| Cooling Method | Forced air cooling |
|---|---|
| Operating Modes | Speed control, torque control, current control |
| Output Current | 15 A to 2000 A (models vary) |
| Communication Interfaces | PROFIBUS, RS232, RS485 |
| Protection Features | Overcurrent, overvoltage, undervoltage, overtemperature, short circuit |
| Enclosure Rating | IP00 |
| Input Voltage | 3-phase, 380-500V AC |
Provides technical specifications for 15-100 ADC drive panels, including voltage, current, and power ratings.
Lists technical data for 140-850 ADC drive panels, covering electrical and environmental parameters.
Specifies technical data for high-current drive panels, including voltage, current, and power ratings.
Offers guidelines for mounting, clearances, and environmental considerations for installation.
Provides electrical schematics for different base drive panel ratings and configurations.
Highlights crucial safety precautions and warnings before initiating drive start-up.
Outlines the steps for parameter entry, adjustment, and selection on the control panels.
Procedure for resetting parameters to factory defaults and adjusting offsets.
Provides a step-by-step guide for configuring and starting up the SIMOREG DC Master drive.
Lists and describes various fault messages, their causes, and system responses.
