Siemens 6RA70 Series User Manual

Siemens Energy & Automation 8-3
SIMOREG DC Master Base Drive Panel Operating Instructions
LED displays
Run green LED
LED illuminated ⇒ in “Torque direction active” state (MI, MII, M0).
(See parameter r000)
Ready yellow LED
LED illuminated ⇒ in “Ready” state (o1 .. o7).
(See parameter r000)
Fault red LED
LED illuminated ⇒ in “Fault signal present” state (o11)
(See parameter r000)
LED flashing ⇒ An alarm is active (see Faults and Alarms).
8.2.2 User-friendly operator control panel (OP1S)
The optional, user-friendly, operator control panel with plain text display (order no.: 6SE7090-0XX84-2FK0)
can be mounted in the special location provided in the converter door or remotely mounted on the enclosure
door. The OP1S connects to the basic converter interface SST1 at sub D connector X300.
Parameters can be selected directly through input of the parameter number by the keyboard of the OP1S.
The following interrelationships apply:
Displayed
number
Number to be keyed in
on OP1S
rxxx, Pxxx
(0)xxx
Basic converter
parameter
Uxxx, nxxx 2xxx
Hxxx, dxxx 1xxx
Technology board
parameter
Lxxx, cxxx 3xxx
For more information on the operation of the OP1S, refer to the power module operating instructions and the
instructions that were provided with the OP1S.

Siemens 6RA70 Series Specifications

General

Brand	Siemens
Model	6RA70 Series
Category	DC Drives
Language	English