To Next PageTo Next Page
Need help?Do you have a question about the Siemens 6SE7041-8EK85-1AA0 and is the answer not in the manual?
General| Type | DC Drive |
|---|---|
| Output Current | 85 A |
| Control Method | Closed-loop control |
| Protection Class | IP20 |
| Product designation | Siemens 6SE7041-8EK85-1AA0 |
| Input Voltage | 380-480 V |
| Output Voltage | 0-400 V |
| Cooling Method | Forced air cooling |
Covers main power connections for different unit sizes, including terminal assignments and diagrams.
Details the connection of the 24V DC power supply and the main contactor circuit.
Explains connections for control terminal blocks, serial interfaces (RS485, RS232), and handling of shielding clamps.
Shows schematic diagrams of the power sections for various unit sizes, illustrating component layouts.
Explains how to connect parallel units of size K to increase output current, including order numbers and connection details.
Covers preparatory measures, reading instructions, forming DC link, and circuit identification before initial operation.
Guides through the parameter settings for a standard application, including language, access stage, and operator control.
Outlines parameter settings for expert applications, including special functions like 12-pulse mode.
Explains the meaning and function of individual control word bits for ON/OFF, Run, Fault, and other commands.
Explains how to activate special functions like factory setting, initialization, download, and circuit identification.
Guides through resetting parameters to factory settings based on MLFB and P077 selection.
Details the procedure for changing the rectifier/regenerating unit's MLFB type setting and parameter reassignments.
Explains the procedure for re-forming DC link capacitors after extended idle periods.
Details the process of identifying the DC link and re-assigning control parameters, crucial for proper operation.
Covers control-related parameters such as status words, current limits, and controller gains.
Explains control and status words, including sources for commands and destinations for messages.
Describes the function of each operator control element on the PMU, including keys and displays.
Provides general information on faults, including available parameters and the process for acknowledging faults.
Provides instructions for replacing key components like fans, modules, and thyristor blocks, including safety precautions.
Guides on how to replace electronic modules in the electronics box, emphasizing ESD precautions and proper handling.
Explains the disassembly and reassembly procedure for thyristor blocks in size H and K units.
Introduces the DriveMonitor software tool for PC-based commissioning, parameterization, and diagnosis.
