To Next PageTo Next Page
Need help?Do you have a question about the Siemens 6SE7033-8EE85-1AA0 and is the answer not in the manual?
General| Product type | DC Drive |
|---|---|
| Type | 6SE7033-8EE85-1AA0 |
| Frequency | 50/60 Hz |
| Protection Class | IP20 |
| Input Voltage | 380-480 V |
| Cooling Method | Air Cooling |
| Communication Interface | PROFIBUS DP |
Explains the use of rectifier/regenerating units as power electronics for supplying DC voltage to SIMOVERT Master Drives inverters.
Describes the function of thyristor bridges, DC link voltage control, and energy exchange between drives.
Illustrates mains and DC link connections for different unit sizes (C, E, H, K) with terminal assignments.
Describes connection of power supply and control circuit for the main contactor via connector X9.
Explains control interfaces including terminal blocks, RS485, and PMU serial interface.
Details the power section diagrams for specific unit models, showing internal connections and components.
Guides through the essential steps for the first start-up of the unit, covering preparatory measures and parameterization.
Lists and explains various tools and parameters that assist in the start-up and operation of the unit.
Covers parameters for controlling the unit, including current and voltage controller gains, limits, and setpoints.
Explains the bits within the control and status words, their meanings, and how they are assigned to sources and destinations.
Lists parameters for configuring serial interfaces (SST1, SST2), SCB, CB, and TB boards for data communication.
Explains the function of each button and display element on the PMU for operating the unit.
Lists and explains various fault codes, their meanings, possible causes, and countermeasures.
Lists and explains various alarm messages, their meanings, and recommended countermeasures.
Details procedures for replacing various components within the unit.
Describes the DriveMonitor software tool for PC-based commissioning, parameterization, and diagnostics.
