Maintenance and diagnostics
52
Building Technologies
048_DMS_NK8000_ICC_MP4.40_A6V10062437_a_en.doc
Fire Safety & Security Products 06.2011
You are logged in as ‘guest’ (default user type) when the NW8204 window ap-
pears.
Note: To change user type (for example from ‘guest’ to ‘admin’), select Change
User to display the Login window. (See information table below.)
User types: There are two ways you can log in to the NW8204 tool.
– Guest user: (Default) User Name = “guest” / Password = “guest”
(recommended – Read-only privileges);
– Administrative user: Call customer support for username and password.
(Read/Write privileges).
Note: Case sensitive – enter letters in lower case only.
Fig. 39 NW8204 window (installed GUI)
2. Insert the NK IP Address (NK82xx).
Note: Inserting an incorrect IP address causes the following window to appear.
If you receive this message, select OK and re-type the IP Address. If you want
to enter the NK82xx default IP address 192.168.9.41, you can use the menu
Set Default IP Address instead of typing it.
Fig. 40 Incorrect IP Address error message
3. If connecting to NK823x, enable the checkbox next to Read Product ID
4. Select Open Connection
NW8204 opens a FTP session on the NK82xx and lists all files available on the
NK82xx flash disk.
To Next Page
Loading...
