The equipment described by this bulletin must be
operated and properly maintained by qualified personnel
who are thoroughly trained and who understand any and
all hazards that may be involved. This bulletin is not
intended to be a substitute for adequate training and
experience in safety procedures for the equipment listed.
Phase-over-phase Vector® group-operated switches (600 and 900 A) Instruction Manual
4
NOTE: These instructions do not purport to cover all details or variations in equipment, nor to
provide for every possible contingency to be met in connection with installation, operation or
maintenance. Should further information be desired or should particular problems arise that are
not covered sufficiently for the purchaser’s purposes, the matter should be referred to the local
sales office.
The contents of this instruction manual shall not become part of or modify any prior or existing
agreement, commitment or relationship. The sales contract contains the entire obligation of
Siemens Industry, Inc. The warranty contained in the contract between the parties is the sole
warranty of Siemens Industry, Inc. Any statements contained herein do not create new
warranties or modify the existing warranty.
A. Inspection of switch components:
1. The palletized P-O-P Vector Switch system includes the following components and
assemblies (see P-O-P Vector assembly drawing for exact Bill of Materials (BOM)):
a. A completely assembled and factory adjusted three-phase switch.
b. Pipe bundles including (consult BOM for exact quantities):
• Vertical operating pipe, seven (7) foot long sections
• Universal joint assembly (steel pipe or fiberglass)
c. Hardware box including (consult BOM for exact quantities):
• Pipe guide assembly
• Lock segment assembly
• Coupling assembly
• Handle assembly
• Insulator assembly (optional)
• Pins
• Cotter pins
To Next Page