Siemens QMX3.P34 User Manual

CM2N1602en_07
2017
-05-22
Building Technologies
s
1
602
QMX3.P37 QMX3.P34 / P74 QMX3.P02 QMX3.P70 QMX3.P30 / P40
Desigo™ TRA
QMX3.P30
Q
MX3.P40
QMX3.P70
QMX3.P02
QMX3.P34
QMX3.P74
QMX3.P37
Wall-mounted sensors and room
operator units for KNX
PL-Link,
KNX S
-mode and KNX LTE-Mode
Communicative sensors, switches and room operator units with KNX (S-mode,
LTE-Mode) or KNX PL-Link (for Desigo™ Total Room Automation)
Functions (depending on type):
• Energy efficiency function ("Green Leaf
")
• Room temperature, CO
2
, and humidity measurement
• Control of light, blinds, and scenes
• PID controller for room temperature or ventilation (KNX S-mode)
• LCD Display for room temperature, operating mode, etc.
• Label for light, blinds and scenes (exchangeable, created with Word
template)
• Operation via 8 or 16 touchkeys
• Interface KNX (S-mode, LTE-Mode) and KNX PL-Link(for TRA, with plug &
play functionality)
• Powered over KNX PL-Link / KNX bus
• LEDs to indicate the switch state or the position of the device in dark rooms

Siemens QMX3.P34 Specifications

General

Brand	Siemens
Model	QMX3.P34
Category	Accessories
Language	English

Summary

Use and Compatibility of Room Operator Units

Use with KNX PL-Link

Describes functions and indications for KNX PL-Link compatibility.

Use with KNX S-mode

Details measurement and control functions for KNX S-mode compatibility.

Use with KNX LTE-Mode

Specifies sensor information usage for KNX LTE-Mode devices.

Engineering and Installation Notes

KNX PL-Link Engineering

Covers plug & play, power, wiring, and installation of KNX PL-Link.

KNX S-mode Engineering

Mentions engineering and commissioning via ETS tool.

KNX LTE-Mode Engineering

Mentions engineering and commissioning via ACS tool.

Device Location and Mounting Height

Provides guidelines for optimal device placement and mounting height.

KNX PL-Link Wiring Guidance

Provides guidance on KNX PL-Link wiring, cable usage, and terminal identification.

Safety Caution

Warns about the risk of accidental connection to AC 230 V.

Commissioning Procedures

Prerequisite: Load Application

Manual Commissioning (KNX PL-Link)

Details addressing, connection testing, and factory reset for KNX PL-Link.

Manual Commissioning (No Display)

Covers addressing, connection test, and factory reset for devices without displays.

Plug & Play Commissioning (KNX PL-Link)

Commissioning (KNX)

Display and Operation

Key Numbering and Functions

Function of Display Elements and Keys

System Specifications and Compliance

Ports: KNX/PL-Link Details

FCC Compliance and Warnings

Details FCC rules, compliance conditions, and potential interference warnings.

Connection and Tool Usage

KNX/PL-Link Plug Wiring

Explains the KNX/PL-Link plug wiring, noting non-interchangeable wires.

ABT Connection to Station