Siemens QMX3.P74 - User Manual

CM2N1602en_07
2017
-05-22
Building Technologies
s
1
602
QMX3.P37 QMX3.P34 / P74 QMX3.P02 QMX3.P70 QMX3.P30 / P40
Desigo™ TRA
QMX3.P30
Q
MX3.P40
QMX3.P70
QMX3.P02
QMX3.P34
QMX3.P74
QMX3.P37
Wall-mounted sensors and room
operator units for KNX
PL-Link,
KNX S
-mode and KNX LTE-Mode
Communicative sensors, switches and room operator units with KNX (S-mode,
LTE-Mode) or KNX PL-Link (for Desigo™ Total Room Automation)
Functions (depending on type):
• Energy efficiency function ("Green Leaf
")
• Room temperature, CO
2
, and humidity measurement
• Control of light, blinds, and scenes
• PID controller for room temperature or ventilation (KNX S-mode)
• LCD Display for room temperature, operating mode, etc.
• Label for light, blinds and scenes (exchangeable, created with Word
template)
• Operation via 8 or 16 touchkeys
• Interface KNX (S-mode, LTE-Mode) and KNX PL-Link(for TRA, with plug &
play functionality)
• Powered over KNX PL-Link / KNX bus
• LEDs to indicate the switch state or the position of the device in dark rooms

Summary

Engineering Notes

KNX PL-Link

Details engineering and commissioning for KNX PL-Link.

KNX S-mode

Details engineering and commissioning for KNX S-mode.

KNX LTE-Mode

Details engineering and commissioning for KNX LTE-Mode.

Mounting and Installation

Prerequisite for Commissioning (KNX PL-Link)

Load Application on the Room Automation Station

Describes how to load the application onto the room automation station.

Manual Commissioning (KNX PL-Link)

Manual Commissioning (KNX PL-Link, Without Display)

Connection Test

Commissioning (Plug & Play, KNX PL-Link)

Commissioning (KNX)

Addressing

Steps for addressing devices for KNX commissioning.

Reset to Factory Setting

Display and Operation

Technical Data

Siemens QMX3.P74 Specifications