EasyManua.ls Logo

Siemens RCD110

Siemens RCD110
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
3339204102-02
3ZW1012-0VM01-4FA0
s
Operating Instructions Betriebsanleitung Notice d'utilisation Instructivo Istruzioni operative
Instruções de Serviço İşletme kılavuzu Руководство по эксплуатации Instrukcja obsługi 使用说明
EN
DANGER
Hazardous voltage. Will cause death or serious injury. Turn off and
lock out all power supplying this device before working on this device.
Replace all covers before power supplying this device is turned on.
NOTICE
Installation and maintenance must be carried out by qualified
personnel.
DE
GEFAHR
FR
DANGER
Gefährliche Spannung. Lebensgefahr oder schwere Verletzungsge-
fahr. Bevor Arbeiten am Gerät durchgeführt werden, müssen alle Strom-
quellen ausgeschaltet und mit einer Einschaltsicherung versehen
werden. Vor dem Wiedereinschalten der Stromquellen müssen alle
Abdeckungen wieder angebracht werden.
Tension électrique dangereuse. Danger de mort ou risque de bles-
sures graves. Avant d'intervenir sur l'appareil, couper toutes les sources
de tension et les consigner contre la refermeture. Remettre en place tous
les couvercles avant de remettre l’appareil sous tension.
HINWEIS NOTIFICATION
Installations- und Wartungsarbeiten sind von qualifiziertem Per-
sonal durchzuführen.
L'installation et la maintenance doivent être effectuées unique-
ment par des personnes qualifiées.
ES
PELIGRO
IT
PERICOLO
Tensión peligrosa. Puede causar la muerte o lesiones graves.
Antes de trabajar en este dispositivo, desconecte y bloquee todas las
fuentes que lo alimentan eléctricamente. Recoloque todas las cubiertas
antes de volver a conectar la alimentación eléctrica para este dispositivo.
Tensione pericolosa. Può causare la morte o lesioni gravi. Prima di
lavorare su questa apparecchiatura, disinserire tutte le fonti di alimenta-
zione elettrica dell'apparecchiatura ed assicurarle contro la reinserzione.
Riapplicare tutte le coperture prima di reinserire l'alimentazione di questa
apparecchiatura.
NOTA NOTA
La instalación y el mantenimiento deben corre a cargo de perso-
nal cualificado.
L'installazione e la manutenzione devono essere eseguite da per-
sonale qualificato.
PT
PERIGO
TR
TEHLİKE
Tensão perigosa. Perigo de morte ou ferimentos graves. Desligue e
bloqueie todas as fontes de alimentação antes de executar quaisquer tra-
balhos no aparelho. Volte a colocar todas as coberturas antes de voltar a
ligar as fontes de alimentação.
Tehlikeli gerilim. Ölüm tehlikesi veya ağır yaralanma tehlikesi mev-
cuttur. Cihazda çalışmalar yapılmadan önce, tüm güç kaynakları kapatıl-
malı ve bir açma emniyetiyle donatılmalıdır. Güç kaynakları tekrar
açılmadan önce tüm kapaklar yerlerine takılmalıdır.
ATENÇÃO NOT
A instalação e manutenção têm de ser efetuadas por pessoal
qualificado.
Montaj ve bakım işlemleri kalifiye personel tarafından yapıl-
malıdır.
РУ
ОПАСНО
РL
ZAGROŻENIE
Опасное напряжение. Опасность для жизни или телесных
повреждений. До начала работы выключите и заблокируйте все
источники питания этого устройства. Перед включением питания
снова установите все крышки.
Niebezpieczne napięcie. Niebezpieczeństwo poważnych obrażeń lub
utraty życia. Wyłączyć i zablokować wszystkie źródła zasilania urządzenia
przed rozpoczęciem pracy na urządzeniu. Założyć wszystkie osłony przed
podłączeniem urządzenia do źródła zasilania.
ПРИМЕЧАНИЕ UWAGA
Установка и техническое обслуживание должны
производиться квалифицированным персоналом.
Instalacja i konserwacja muszą być wykonywane przez wykwali-
fikowany personel.
Technical Support: Internet: http://www.siemens.com/lowvoltage/technical-support
Last Update: 10 September 2018
RCD basic type A, side mounted, 160A, 250A / RCD110, RCD210
Differenzstromschutzgerät Basic Typ A, seitlich montiert,160A , 250A / RCD110,
RCD210
Bloc différentiel basic type A rapporté latéralement, 160A, 250A / RCD110,
RCD210
Dispositivo diferencial, tipo básico A, montado lateralmente,160A, 250A /
RCD110, RCD210
Aparelho de corrente diferencial Tipo básico A, montado lateralmente, 160A,
250A / RCD110, RCD210
Interruttore differenziale Basic Tipo A, montaggio laterale, 160A, 250A /
RCD110, RCD210
Diferansiyel akım cihazı Basic Tip A, yana monte, 160A, 250A / RCD110, RCD210
Устройство дифференциального тока Basic Тип А, с боковым монтажом,
160A, 250A / RCD110, RCD210
Urządzenie RCD, podstawowe, typ A, montowane z boku, 160A, 250A / RCD110,
RCD210
剩余电流装置模块基础版 A 型,侧面安装,160A, 250A / RCD110,RCD210
3VM9.14-ORS.0 IEC 60947-2
Question and Answer IconNeed help?

Do you have a question about the Siemens RCD110 and is the answer not in the manual?

Siemens RCD110 Specifications

General IconGeneral
Number of poles2
Tripping current30 mA
Mounting TypeDIN rail
Protection ClassIP20
Endurance (mechanical)10000 operations
Rated current In16 A
Frequency50 Hz
StandardsIEC 61008-1

Summary

Required Tools

Tools Overview

Lists necessary tools for installation and maintenance, including screwdrivers and measurement tools.

Contents

Included Components

Details the items included in the product package for different models.

Assembly

Mounting Procedure Steps

Illustrates sequential steps for assembling the RCD unit, marked with numbers 1 to 5.

Assembly

Assembly Steps and Torque

Details assembly steps, including torque specifications for connections and component mounting.

Connection

Wiring Diagrams and Options

Presents wiring diagrams and options for connecting the RCD, showing terminal connections.

Assembly

Assembly and Testing Steps

Illustrates further assembly steps and the initial testing sequence for the RCD unit.

Connection

Connection Options and Diagrams

Details connection options, wiring configurations, and electrical specifications for the RCD.

Settings

Parameter Adjustment

Describes how to adjust settings for the RCD, including torque specifications for mounting.

Test

Isolation Test Procedure

Illustrates the steps for performing an insulation test on the RCD unit.

Test

Electrical Test Procedures

Details electrical testing procedures, including insulation resistance and voltage ratings.

Information

Product Specifications

Provides key electrical specifications, voltage ratings, and technical data for the RCD.

Information

Operating Status Indicators

Explains the meaning of different LED indicators and operational states of the RCD.

Test

Annual Safety Test

Highlights the requirement for an annual safety test due to hazardous voltage.

Test

Tripping Test Procedure

Illustrates the steps for performing a tripping test on the RCD unit.

Settings

Tripping Behavior Settings

Explains how to set tripping behavior based on IΔn and release delay (Δt).

Information

Dimensional Drawings

Provides detailed dimensional drawings and specifications for the RCD unit.

Related product manuals