Need help?Do you have a question about the Siemens SWT-3000 and is the answer not in the manual?
General| Cut-out Wind Speed | 25 m/s |
|---|---|
| Rated Wind Speed | 13 m/s |
| Rated Voltage | 690 V |
| Frequency | 50 Hz / 60 Hz |
| Rated Power | 3000 kW |
| Hub Height | 80 m |
| Operating Temperature Range | -20°C to +40°C |
| Generator Type | Doubly-fed induction generator (DFIG) |
| Cooling System | Air-cooled |
| Protection Class | IP54 |
Explains the different operational modes, including analog and digital interface configurations.
Describes the various protection operating modes offered by the SWT 3000 system.
Crucial safety measures to prevent injury and equipment damage during installation and operation.
Guide on connecting the SWT 3000 device, including modules and interfaces without FOM.
Configuration of jumpers on various modules (IFC, PU3, CLE, FOM, FOB, ALRS, ALR) for proper operation.
Procedures for initial setup, including power supply, device startup, and service PC connection.
Overview of the PowerSys software for commissioning, maintenance, and diagnosis of PowerLink and SWT 3000 units.
Guide for using MemTool to perform firmware downloads and upgrades for PowerLink and SWT 3000 units.
Explains the role of the PU3f as the central control module, processing commands and managing interfaces.
Explains the ALRS module's role as an interface for alarm and signaling points to the PU3.
Describes the ALR module's features, including binary inputs, relay outputs, visual indication, and test switches.
Essential safety precautions for handling and operating the equipment, particularly concerning ESD.
General information and function of the SNMP server for network management and status monitoring.
General information and examples of how to establish remote access to SWT 3000 devices using PowerSys.
To Next Page