SNMP and Remote Access SWT 3000 Equipment Manual
Page - 12 Edition p3_3_2x 08/09 © SIEMENS AG 2008
SWT 3000 alarms
Two events (active/not active) are assigned to each alarm and transmitted to the programmed
NMS in case of a change of state during a configured time period. Cyclic repetitive alarms within an
adjustable time period are transmitted once only. Each alarm contains the severity level and a short
description of the event.
The following SWT 3000 alarms are transmitted from the SNMP server:
• alarmPowerSysSession (severity 5)
A PowerSys session occupies the serial interface to the SWT 3000. SNMP data can’t
be refreshed during this time.
• alarmHardware (severity 1)
The SWT 3000 device reports hardware alarm. One or more configured hardware
components are not available or faulty.
• alarmConfiguration (severity 1)
The SWT 3000 reports configuration alarm. The adjusted device configuration is not
valid.
• alarmGeneral (severity 1)
The SWT 3000 reports general alarm
• alarmNonUrgent (severity 2)
The SWT 3000 reports non urgent alarm
• alarmRx (severity 1)
The SWT 3000 reports receiver alarm
To Next Page
Loading...
