SWT 3000 Equipment Manual Chapter 3: Service program PowerSys
© SIEMENS AG 2008 Edition p3_3_2x 08/09 Page - 27
Starting MemTool
For launching MemTool as a stand-alone tool, execute Memtool.exe via the Windows Main menu
Start - Programs -UDE MemTool.
Figure 35: Memtool with the PowerLink target
Figure 36: Selecting the Siemens PowerLink-CSP target
Wrong target selection will result in unsuccessful flash programming. Ver-
ify that the target selected is the device physically connected.
When starting MemTool for the
first time, the Select Target
Configuration dialog is dis-
played. Otherwise, this dialog
can be reached via menu Tar-
get – Change.
Select Siemens PowerLink-
CSP and click OK.
To Next Page
Loading...
