Siemens SWT-3000 - Spontaneous Indication SNMP Traps; General Traps; SNMP Agent Specific Traps

SWT 3000 Equipment Manual SNMP and Remote Access
© SIEMENS AG 2008 Edition p3_3_2x 08/09 Page - 11
Spontaneous indication SNMP traps
Spontaneous indication from the SWT 3000 device are transmitted from the SNMP server to the
configured Network Management Systems. Up to 6 NMS can be configured for receiving this traps.
Each trap is sent with a severity (1-5) with the following signification:
Table 1: Alarm severity
Alarm severity Signification
1 Critical
2 Major
3 Minor
4 Warning
5 Normal
General traps
• Cold start (severity 1)
A cold start trap signifies that the SNMP server is reinitializing itself and that its con-
figuration may have been altered.
• Authentication failure (severity 2)
An authentication failure trap signifies that the SNMP has received a protocol mes-
sage that is not properly authenticated.
SNMP agent specific traps
• agentLinkstatus (value 0, severity 1)
This trap is transmitted when the RS232 connection between the SNMP server and
the SWT 3000 is interrupted.
• agentLinkstatus (value 1. severity 1)
This trap is transmitted when an interrupted RS232 connection between the SNMP
server and the SWT 3000 is successfully recovered.