Siemens SWT-3000 - Appendix

CLE Module SWT 3000 Equipment Manual
Page - 12 Edition p3_3_x 08/09 © SIEMENS AG 2008
Appendix:
List of figures
Figure 1:
Block diagram of the CLE module ---------------------------------------------------------------------------------- 3
Figure 2: The input circuit of the CLE module-------------------------------------------------------------------------------- 4
Figure 3: Block diagram of the transmit amplifier --------------------------------------------------------------------------- 4
Figure 4: Displays on the CLE module----------------------------------------------------------------------------------------- 5
Figure 5: Block diagram of the S6 control------------------------------------------------------------------------------------- 6
Figure 6: Position of the jumpers on the CLE module----------------------------------------------------------------------- 7
Figure 7: Cable connection from the CLE to the PLC unit ESB 2000i----------------------------------------------------- 9
Figure 8: Connecting an external SWT 3000 to the port 3 of the VFx modules------------------------------------------- 9
Figure 9: Connecting an external SWT 3000 to the port 4 of the VFx modules------------------------------------------10
List of tables
Table 1:
Jumper settings for the input and output impedance ---------------------------------------------------------------- 7
Table 2: Jumper settings for the receive signal gain--------------------------------------------------------------------------- 7
Table 3: Connector pin assignment of the CLE module ----------------------------------------------------------------------- 8