30 / 40
Siemens RDF300…/RDF340.../RDF400… Basic Documentation CE1P3076en
Building Technologies 5BHandling 28 Aug 2008
• Recalibrate the temperature sensor if the room temperature displayed on the
controller does not match the room temperature measured. To do this, change
parameter P05
• We recommend to review the setpoints and setpoint ranges (parameters
P08…P12) and change them as needed to achieve maximum comfort and save
energy
5.2 Operating Instructions
See the operating instructions B3076 enclosed with the controller.
5.3 Disposal
The device is classified as waste electronic equipment in terms of the European
Directive 2002/96/EC (WEEE) and should not be disposed of as unsorted muni-
cipal waste.
The relevant national legal rules are to be adhered to. Regarding disposal, use
the systems setup for collecting electronic waste.
Observe all local and applicable laws.
Calibrate sensor
Setpoint and range
limitation
To Next Page
Loading...
Need help?
General
