Modem Command Set Reference Manual
page 7 of 7
The commands in Table 2 are used to configure the modem .All other AT commands
specified by leading +C are descripted in the AT Command Set Reference Manual.
Command Function, defaults Implementation comments Reference
+CBST 7,0,1 (9600 bps) GSM07.07
+CRLP 61,61,58,6 GSM07.07
+CR 0 GSM07.07
Table 2: Local AT+C (Cellular) Commands
S-Register Function (default values in bold type)
S 0 The number of rings before the Gipsy Soft answers the call (Default: 0, does not answer)
S 3 Command termination character and first character of response trailer (CR)
S 4 Second character of response trailer (LF)
S 6 Editing character; erases the previous character (BS)
S 6 Escape character
S 7 Wait for carrier after dialling (in seconds). (Default: 60)
S 8 + S 9 No Action
S 10 Delay between Lost Carrier and Hang up in 0.1 sec. (Default 2 = 200ms)
S 11 .. S17 No Action
S 18 Bit
0 0 no GSM exit cause 1 with GSM exit cause
1 0 no SMS Indication ‘+C...’ 1 with incoming SMS Indication ‘+C..’
S 19 ... S99 No Action
Table 3: S-Registers
To Previous Page
Loading...
