V1.00 Page 25 of 49 ICM MP CCQ GRM
S55/S57 Company Confidential © Copyright Siemens AG 12/02
Measurement of Battery and Ambient Temperature
The battery temperature is measured via the voltage divider R1387, R138 by the
EGOLD+
(Analog Interface P2). For this, the integrated Σ∆ converter of the RX-I base
band branch is used. This Σ∆ converter compares the voltage of TBAT and TENV
internally. Through an analogue multiplexer, either the RX-I base band signal, or the
TBAT signal and the TENV signal is switched to the input of the converter. The signal
MEAS_ON from the EGOLD+
(GSM TDMA-TIMER H15) activates the battery voltage
measurement The ambient temperature TENV is measured directly at of the EGOLD+
(Analog Interface P3).
Measurement of the Battery Voltage
The measurement of the battery voltage is done in the Q-branch of the EGOLD+, for
this BATT+ is connected via a voltage divider R143, R146 to the EGOLD+
(Analog
Interface P1)
. An analogue multiplexer does the switching between the baseband signal
processing and the voltage measurement.
To Next Page
Loading...
