20
Call Waiting Tone Switch
Command-No / Meaning Parameter value Default
341 call waiting tone
at a/b1-interface
0 = off
1 = on
1
342 call waiting tone
at a/b2-interface
0 = off
1 = on
1
The call waiting tone is a tone in the receiver signaling an incom-
ing call during a call is already ongoing. This service is not
available at every network provider.
The incoming call can be answered by finishing the ongoing call
(hook on, SANTIS-ab rings, hook off).
The call waiting tone can be switched off, e.g. if a fax machine or
a modem is connected to the a/b-interfaces.
Restrictions for NT+2ab/CA restr. and Pairgain:
a/b1 via a/b1 only; a/b2 via a/b2 only.
To Next Page
Loading...
Need help?
General
