Siemens SCALANCE M874-2 - Approvals

SCALANCE M874, M876
Operating Instructions, 06/2015, C79000-G8976-C331-05
63
Approvals
A
Approvals issued
Note
Issued approvals on the type plate of the device
The specified approvals apply only when the corresponding mark is printed on the product.
You can check which of the following approvals have been granted for your product by the
markings on the type plate.
Approvals for shipbuilding are not printed on the device type plate.
WARNING
Personal injury and property damage can occur
The installation of expansions that are not approved for SIMATIC NET products or their
target systems may violate the requirements and regulations for safety and electromagnetic
compatibility.
Only use expansions that are approved for the system.
●
Keep to the installation guidelines
The devices meet the requirements if you adhere to the installation and safety
instructions contained in this documentation and in the following documentation when
installing and operating the devices.
●
You can always find the latest documentation on the Internet
The current descriptions of the currently available products can always be found on the
Internet under the specified entry IDs/Internet pages:
– "Industrial Ethernet / PROFINET Industrial Ethernet" System Manual
– "Industrial Ethernet / PROFINET - Passive network components" System Manual
You will find information on the system manuals in the section "ID = 27069465
(http://support.automation.siemens.com/WW/view/en/27069465)", in "Further
documentation".
– "EMC Installation Guidelines" configuration manual
ID = 60612658 (http://support.automation.siemens.com/WW/view/en/60612658)