NAT_S615
Entry ID: 109744660, V1.1, 08/2017
Siemens AG All rights reserved
Remarks
Address translation using source NAT is performed behind the firewall;
consequently, the physical addresses must be used here.
Destination NAT has already been performed before the firewall; consequently,
the translated addresses must be used here.
The "Trans.Destination IP Subnet” columns in the SCALANCE S615 may only
be configured with a single IP address – /32. Only then does the SCALANCE
S615 reply to ARP requests for the additional IP addresses.
To Next Page
Loading...
