Siemens SCALANCE W734-1 RJ-45

Description of the device
4.4 Accessories
SCALANCE W774-1 / W734-1
28 Operating Instructions, 03/2022, C79000-G8976-C325-15
Type
Properties
Article number
ANT795-4MD
Omnidirectional antenna, 3/5 dBi, 2.4 GHz
and 5 GHz, IP65, N-Connect male for
direct installation on the device, 90°
connector.
6GK5795-4MD00-0AA3
ANT795-4MX
Omnidirectional antenna, 2/2.5 dBi,
2.4 GHz and 5 GHz, IP69K, N-Connector
male
6GK5795-4MX00-0AA0
ANT795-6DC
Wide angle antenna, mast/wall mounting,
9 dBi 2.4 GHz and 5 GHz, N-Connect
female
6GK5795-6DC00-0AA0
ANT795-6MN
Omnidirectional antenna, mounted on
roof/vehicle, 6/8 dBi 2.4 GHz and 5 GHz,
N-Connect female
6GK5795-6MN10-0AA6
ANT795-6MT
Omnidirectional antenna (MIMO),
mounted on roof/vehicle/ceiling, 5/7 dBi
2.4 GHz and 5 GHz, 3 x QMA connector
female
6GK5795-6MT00-0AA0
ANT795-6MP
Omnidirectional antenna, 5/7 dBi, 2.4 GHz
and 5 GHz, IP65/67, N-Connector female
6GK5795-6MP00-0AA0
IWLAN RCoax Cable
2,4 GHz PE 1/2"
Omnidirectional antenna, 0 Bi 2.400 -
2.485 GHz, N-Connect female
6XV1875-2A
IWLAN RCoax Cable
5 GHz PE 1/2"
Omnidirectional antenna, 0 Bi 5.150 -
5.875 GHz, N-Connect female
6XV1875-2D
NOTICE
ANT795-4MA
The ANT795-4MA antenna has degree of protection IP30 and is therefore only suitable
for dry environments.
Note
ANT793
-8DJ
The antenna ANT793
-8DJ may only be used with the flexible connecting cable 6XV1875-
5CH50 (5 m length) or 6XV1875
-5CN10 (10 m length). Other flexible connecting cables
are not permitted.
Notice for USA/Canada
Only one antenna per device can be used (connect
ed to R1A1, R1A2 or R2A1, R2A2).
Note
ANT793
-8DK
The antenna ANT793
-8DK may only be used with the flexible connecting cable 6XV1875
-
5CN10 (10 m length). Other flexible connecting cables are not permitted.
Notice for USA/Canada
Only one antenna per device can be used (connected to R1A1, R1A2 or R2A1, R2A2
).