Maintenance and troubleshooting
Ordering replacement parts
When ordering replacement parts for a
Siemens Power
Circuit Breaker, it is very important to give
complete
information. This information should
include:
1. Type SDV6 distribution circuit breaker
serial number listed on circuit breaker
nameplate.
2. Type of operator listed on operator
nameplate.
3. Type of circuit breaker.
4. Rated continuous current of circuit
breaker.
5. Rated voltage of circuit breaker.
6. Description of part. Use instruction
book description insofar as possible.
7. Instruction book number listed on
circuit breaker nameplate.
8. Instruction book item number.
9. Number of pieces required.
While the circuit breaker can be identified
by the serial number alone, all additional
information that is given will serve as a
check to be certain that the part or parts
furnished are correct for the circuit breaker
in question. Without this serial number,
Siemens cannot be sure of the correct
identity of the desired parts.
If any doubt exists as to the instruction
book reference number or the description,
a dimensional sketch of the desired part
will help to properly identify it.
Siemens recommends that a supply of
repair parts be kept on hand so that
emergency repairs can be made without
waiting for shipment of parts from the
factory.
A list of recommended spare parts is sent
with the circuit breaker. Before removing
any part to be replaced, observe its
function and adjustment. This usually
saves adjustment time during installation.
37
To Next Page
Loading...
