Siemens Series 2300

Installation Instructions
Document No. 129-479
November 13, 2012
Series 2300 Room Units
for TALON® Controllers
Item Number 129-479, Rev. HA
Page 1 of 6
Product Description
These room units measure temperature in the
occupied space in which they are installed. Models
with display allow users to view the measured
temperature value. A version with temperature
setpoint adjustment is also offered.
These devices are intended for use with appropriate
signal input on a TALON Controller. The effective
sensing and setpoint range is 55°F to 95°F (13°C to
35°C).
These room units can be mounted on electrical
boxes, stud-type mounting brackets, or drywall.
Obtain the necessary mounting hardware and follow
the appropriate mounting procedures for the type of
installation required.
Product Numbers
QAA2312.xWxN
QAA2330.xWxx
QAA23SS.xWxN
QAA23SS.xWxx
Accessories
AQA2200-INTL Room Unit Back Plate (10-pack)
AQA2200-2X4 Room Unit Back Plate (Single)
NOTE: If installing the Back Plate, discard the
metric screws provided with the Back Plate
and utilize the Room Unit mounting screws.
Caution Notations
CAUTION
Equipment damage or loss of
data may occur if you do not
follow a procedure as
specified.
Expected Installation Time
20 minutes
Required Tools
• Sizes 1 and 2 Phillips screwdrivers
• Small and medium flat-blade screwdrivers
• 1/16-inch hex key
• Medium-duty electric drill
• 3/16-inch (4.8 mm) drill bit
• One-inch (25 mm) hole saw
• Small level
• Tape measure
• Marker or pencil
Prerequisites
• Review these instructions before beginning.
• Installed: appropriate field wiring within the
maximum wiring run length for the individual
equipment controller. The maximum
recommended length is 100 feet (30 m).
• All wiring must comply with National Electric
Code (NEC) and local regulations.
Figure 1. QAA23xx.EWTN, and QAA23xx.FWTN
Room Units.

Siemens Series 2300 Specifications

General

Brand	Siemens
Model	Series 2300
Category	Control Panel
Language	English

Summary

Series 2300 Room Units for TALON Controllers

Product Description

Describes the function of Series 2300 Room Units for TALON Controllers, including sensing and setpoint range.

Product Numbers

Lists the specific product numbers for the Series 2300 Room Units.

Accessories

Lists available accessories such as back plates for the Room Units.

Caution Notations

Warns about potential equipment damage or data loss if procedures are not followed.

Expected Installation Time

Estimates the time required for installation.

Required Tools

Lists the necessary tools for installing the Series 2300 Room Units.

Prerequisites

Outlines requirements before starting installation, including wiring and code compliance.

Mounting Information

Room Unit Location Guidelines

Provides guidelines for selecting an optimal location for the room unit.

Drywall Mounting (No Rough-in)

Details the steps for mounting the room unit on drywall without a rough-in.

Base Plate Mounting and Wiring

Covers mounting the base plate and initial wiring connections.

Electrical Box and Rough-in Mounting

Power Connection Safety Precautions

Details safety precautions for connecting AC or DC power to prevent damage.

Controller Wiring Scenarios

Wiring Diagrams and Notes

Presents wiring diagrams and specific notes for connecting the room unit to controllers.

Power Supply Configurations