Need help?Do you have a question about the Siemens SINAMICS BOP-2 and is the answer not in the manual?
General| Product type designation | BOP-2 |
|---|---|
| Communication Interface | RS232 |
| Power Supply | 24 V DC |
| Protection Class | IP20 |
| Degree of protection | IP20 |
| Display | LCD |
| Interface | USB |
| Operating Temperature | 0 to 55 °C |
| Ambient temperature during operation | 0 to 55 °C |
| Relative Humidity | 5 to 95 % |
Updates to the BOP-2 commissioning process for efficiency and adaptability.
Warning notifications have been upgraded to Danger notifications.
Updated compatible products list and menu structure.
Details on firmware updates and new commissioning behavior.
Instructions to prevent severe injury or death by observing safety protocols.
Risks and measures for software manipulation and industrial security.
Specific warnings and cautions for safe operation and handling.
The BOP-2 enhances interface and communication for SINAMICS Inverters.
Physical layout, display, and connections of the BOP-2.
Detailed functions of each key on the BOP-2 keypad.
Explanation of icons used on the BOP-2 display for status indication.
Overview of the menu structure for accessing functions.
Step-by-step guide for physically fitting the BOP-2 to the Control Unit.
Procedure for powering up and establishing communication after installation.
Accessing and navigating the monitoring menu.
Details of displayed values for setpoint, voltage, and DC Link.
Details for current, frequency, RPM, and voltage/current displays.
Accessing Setpoint, Jog, and Reverse functions.
Switching between manual and automatic control modes.
How to adjust the motor speed setpoint.
Manual motor rotation and direction control.
Accessing fault, history, and status information.
Procedures for acknowledging faults and viewing fault history.
Understanding control and status words for troubleshooting.
Navigating parameter menus and using filters.
Methods for modifying parameter values via single digit or scrolling.
Introduction to the setup menu and standard commissioning.
Step-by-step process for configuring the inverter for a motor.
Overview of functions like Drive Reset and data management.
Resetting, saving, and loading data to/from RAM, ROM, BOP, and memory card.
Physical dimensions, weight, and environmental operating conditions.
To Next Page