Siemens SINAMICS BOP-2 - Initial Startup Procedure

Installation
Basic Operator Panel 2 (BOP-2)
20 Operating Instructions, 02/2016, A5E37143404B AA
Initial startup
After connection and power-up the BOP-2 automatically detects the type of Control Unit then
attempts to establish communications.
On startup the BOP
-2 will display the company name and the
class of O
perator Panel.
The BOP
-2 will then display the current software version of
the Operator Panel.
The BOP
-2 will then establish communications between the
Operator Panel and the Control Unit.
Once communications have been established, an internal
check is performed to ensure that the Operator Panel is r
e-
sponding correctly.
Once all checks have b
een completed the BOP-2 will display
the standard status screen. The BOP
-2 is now ready for use.
After establishing communications, if a fault or alarm cond
i-
tions is present, the BOP
-2 displays the relevant fault or
alarm number.
If more than one fault or alarm conditions exis
ts, use the
and
keys to move through the list on the screen.