Siemens SINAMICS BOP-2 - Overview; Introduction to BOP-2

Basic Operator Panel 2 (BOP-2)
Operating Instructions, 02/2016, A5E37143404B AA
13
Overview
4
Introduction
The Basic Operator Panel 2 (BOP-2) has been designed to enhance the interface and
communications capabilities of SINAMICS Inverters.
The BOP-2 connects to the Inverter through an RS232 interface. The BOP-2 automatically
recognize all variants of the following Control Units from the SINAMICS range:
● SINAMICS G120 CU230P-2
● SINAMICS G120 CU240B-2
● SINAMICS G120 CU240E-2
● SINAMICS G120 CU250S-2
● SINAMICS G120C
Note
BOP-2 functional support
The BOP
-2 supports all of the previously listed Control Units with firmware version 4.3
Service Pack 2 (SP2) or later.