Siemens SINAMICS BOP-2 - Parameter Editing Methods

Parameters
Basic Operator Panel 2 (BOP-2)
34 Operating Instructions, 02/2016, A5E37143404B AA
Image 9-1 Selecting standard or export parameter filters
Editing the parameters
There are two methods to edit and modify parameters, these are:
● Single digit
● Scrolling
Single digit editing of the parameters is accomplished by a long press of the
key. Each
individual digit of the parameter can be modified using the
and keys and individual
confirmed by a press of the
key.
This method of editing the parameters are shown in the following figure (the
symbol
denotes where the display will automatically display a new screen on the completion of a
process).