To Next PageTo Next Page
Need help?Do you have a question about the Siemens SIMATIC HMI KTP700 Basic and is the answer not in the manual?
General| Display Size | 7 inch |
|---|---|
| Display Type | TFT |
| Resolution | 800 x 480 pixels |
| Touchscreen | Yes |
| Backlighting | LED |
| Power Supply | 24 V DC |
| Operating Temperature | 0 to 50 °C |
| Storage Temperature | -20 to 60 °C |
| Weight | 0.8 kg |
| Color Depth | 16-bit |
| Processor | ARM |
| Interface | Ethernet |
| Protection Rating | IP65 |
New, cost-efficient HMI generation meets the trend for high-quality visualization.
Provides essential safety guidelines for operating and installing the HMI device.
Covers pre-installation checks like package contents and operating conditions.
Explains the procedure for physically installing the HMI device.
Details the sequence and steps for connecting the HMI device.
Guides on how to power on and perform initial tests on the HMI device.
Guide on how to access and use the device's settings menu.
Lists and describes the functions available in the Start Center for device configuration.
Procedure for backing up HMI device data to external storage.
Procedure for restoring HMI device data from external storage.
How to load a project from external storage to the HMI device.
Steps to update the HMI device's operating system from external media.
Instructions to assign IP addresses and device names to controllers.
How to modify parameters of configured controller connections.
How to set up password protection for the Start Center.
Configuration of network parameters for PROFINET devices.
Configuration of network parameters for PROFIBUS devices.
Setting parameters for project and image data transfer.
Steps to configure the Sm@rt Server for remote access.
Procedure for recalibrating the touch screen for accurate input.
Introduction to the project configuration and process control phases.
Describes the different operating modes: Offline, Online, and Transfer.
General information about transferring projects to the HMI device.
Steps to manually initiate project transfer to the HMI device.
