Siemens SIMATIC HMI KTP700 Basic - Safety instructions; General safety instructions

Basic Panels 2nd Generation
Operating Instructions, 10/2016, A5E33293231-AB
17
Safety instructions
2
2.1
General safety instructions
Working on the control cabinet
WARNING
Open equipment
The HMI device is an open equipment. This means the HMI device may only be installed in
cubicles or cabinets that provide front panel access for operating the device.
The cubicle or cabinet in which the HMI device is installed may only be accessed with a key
or tool and only by trained, authorized personnel.
Dangerous voltage
Opening the cabinet will expose high voltage parts. Contact with these parts could be fatal.
Always disconnect the cabinet from the mains before opening it.
Installation as intended
WARNING
Installation only in machinery that conforms to the machinery directive
You are not permitted to commission the HMI device unless it has been verified that the
machine in which the HMI device is to be installed complies with directive 2006/42/EC.