Need help?Do you have a question about the Siemens SG035 Series and is the answer not in the manual?
General| Protection Class | IP20 |
|---|---|
| Output Frequency | 0 to 650 Hz |
| Control Method | V/f control |
| Communication Interfaces | Modbus RTU |
| Cooling Method | Forced air cooling |
Manufacturer recommends installation/service by authorized dealer. Operator must comply with codes.
Dangers of electrical shock. Avoid contact with bare wires & wet conditions. Ensure proper grounding.
Keep fire extinguisher nearby. Do not use carbon tetrachloride type. Ensure proper ventilation.
Ensure proper ventilation. Do not smoke near generator. Keep area clean. Handle fuels with care.
Understand all instructions before operating. Contact dealer if any part is unclear.
Operator responsible for safety checks & prompt maintenance. Proper care ensures fewer problems.
Contact Authorized Service Dealer for service/repair. Provide model & serial number.
Contains data label with serial number, voltage, amps, wattage, phase, frequency, and RPM.
Describes generator set, components like enclosure, muffler, control console, and circuit breaker.
Automatic shutdown devices for low oil pressure, high coolant temp, low coolant level, and overspeed.
Covers natural gas, propane vapor, and LP fuel systems, including requirements and pressure.
Lists generator specs: type, insulation, THD, TIF, output leads, bearings, coupling, and rating.
Provides engine details: make, model, displacement, bore, stroke, compression ratio, and air intake.
Covers battery charger, static charger, battery, system voltage, voltage regulator, sensing, and regulation.
Step-by-step instructions to reconfigure fuel system from natural gas to LP vapor.
Covers checks for transfer switch, fuel system, generator lubrication, and prior to initial start-up.
Details checks for engine coolant, belt tension, and electrical system before first start.
Lists crucial items to inspect before starting generator, e.g., freight damage and fluid levels.
Provides step-by-step checklist for preparing, starting, and testing the generator set.
Details starting engine and transferring load with manual transfer switch. Includes safety warnings.
Explains how to transfer load back to utility power and properly shut down the generator.
Describes operation with automatic transfer switch, including start/stop procedures.
Lists maintenance tasks for authorized service facilities at various intervals.
Covers checking engine oil, battery fluid, and engine coolant levels.
Provides step-by-step instructions for changing engine oil and oil filter.
Covers inspection of battery posts, cables, fluid levels, and state of charge.
Lists common problems, causes, and corrections for engine & generator issues.
Outlines limited warranty for Generac generators, including coverage, exclusions, and guidelines.
Details warranty coverage for years one and two, including components, labor, and parts.
Provides guidelines for warranty claims, including service by authorized dealers and recommended maintenance.
Lists conditions voiding warranty: misuse, improper installation, external causes.
To Next Page