Need help?Do you have a question about the Siemens SINAMICS G120P and is the answer not in the manual?
General| Frequency Range | 0 Hz to 550 Hz |
|---|---|
| Ambient Temperature | -10°C to +50°C |
| Storage Temperature | -40°C to +70°C |
| Relative Humidity | 5% to 95% (non-condensing) |
| Voltage Range | 200 V to 240 V, 380 V to 480 V, 500 V to 690 V |
| Output Voltage | 0V to input voltage |
| Control Type | Vector control, V/f control |
| Protection Class | IP20, IP55 |
| Communication Interfaces | PROFIBUS, PROFINET, Modbus RTU |
| Cooling Method | Air cooling |
| Altitude | Up to 2000 m without derating |
| Power Range | 0.37 to 630 kW |
General safety instructions for handling electrical equipment and preventing hazards.
Covers connection procedures for line supply and motor, including warnings and restrictions.
Provides a flowchart and step-by-step guide for commissioning the inverter, from defining requirements to saving settings.
Guides through quick commissioning using the BOP-2 operator panel, including inserting the panel and starting the process.
Provides detailed procedures for backing up and transferring inverter settings using memory cards.
Describes write protection to prevent unauthorized changes to inverter settings, applicable to all user interfaces.
Explains know-how protection to prevent unauthorized reading of inverter settings, including activation and copy protection.
Covers firmware upgrades and downgrades, including preparing a memory card and the upgrade/downgrade procedure.
Offers procedures to restore factory settings when the inverter no longer responds, covering different cases.
To Next Page