Need help?Do you have a question about the Siemens SIMOVERT MASTERDRIVES 6SE70 VC and is the answer not in the manual?
General| Input Voltage | 380-480V AC |
|---|---|
| Output Voltage | 0-480V AC |
| Control Method | Vector Control, V/f Control |
| Cooling Method | Forced Air Cooling |
| Protection Class | IP20 |
| Enclosure Rating | IP20 |
| Model | 6SE70 |
| Input Frequency | 50/60 Hz |
| Output Frequency | 0-300 Hz |
| Communication Interfaces | Profibus |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit |
| Ambient Temperature Range | 0°C to +40°C |
| Storage Temperature Range | -25 to +70 °C |
| Relative Humidity | 5% to 95% non-condensing |
Defines the drive's power section configuration.
Restores drive parameters to factory default values.
Guides through the initial setup and configuration process.
Basic start-up using Volts/Hz control without encoder.
Start-up using Volts/Hz control with encoder feedback.
Start-up using Vector Control without encoder feedback.
Start-up using Vector Control with encoder feedback.
Configuration of the drive's control word for operation.
Setup and configuration of communication boards.
Defines the power section for rectifier units.
Resets rectifier unit parameters to factory defaults.
Basic start-up for rectifiers without an auto-transformer.
Basic start-up for rectifiers with an auto-transformer.
Instructions for loading and launching the Simovis software.
Setting up the drive connection and communication parameters in Simovis.
Configuring trace recording intervals, channels, and trigger conditions.
Steps to start tracing, observe status, and analyze recorded data.
Situations like hardware, physical, or software changes requiring drive re-tuning.
To Next Page