Version 1.0 March 1, 2000 Page 7
1.1 Power Section Definition
Note: Power Section is pre-defined at the factory. Power Section
Definition is required if a new board CUVC board is put into the drive or
boards are switched between units with different ratings. Drive should
be defaulted and re-parameterized after Power Section Definition.
P060 = 8
P070 = ?
P060 = 1
Select “Power Section Definition”
Menu
Input Code for unit (PWE)
(Refer to Compendium section
6.3 or use the bookmark “PWE
Listing” or check the following
table)
Return to Parameter Menu
To Next Page
Loading...
Need help?
General