Siemens SIMATIC HMI KP1500 Comfort - Input and Display Operations

Operating a project
6.5 Input of values
Comfort Panels
178 Operating Instructions, 07/2017, A5E36770603-AB
Selecting a language
You can change project languages at any time. Language-specific objects are immediately
output to the screen in the new language when you switch languages.
The following options are available for switching the language:
● A configured operating element switches from one language to the next in a list
● A configured operating element directly sets the desired language
Refer to your system documentation to find any additional information on this topic.
6.5
Input of values
If you select an I/O field in the project using the tab sequence or by touch, the entire field
content is selected. The screen keyboard appears on a touch HMI device.
Procedure
Proceed as follows:
1. To overwrite the value:
– Enter the new value using the system keys or the screen keyboard.
2. To change the value:
– Key HMI device: Deselect the content with <SHIFT+Right>.
– Touch HMI device: Deselect the content with any cursor key.
– Move the cursor to the desired location and change the value.
3. Close the value entry.
Result
The value of the I/O field is set.
See also
Entering and editing numerical values (Page 179)
Entering or changing alphanumeric values (Page 180)
Entering values with system keys (Page 73)
Reference for system keys (Page 69)