Configuration, programming
4.9 Program blocks for OUC
CP 1543-1
70 Operating Instructions, 12/2019, C79000-G8976-C289-08
manually in the declaration table of block instead of selecting an entry from the "Data type"
drop-down list. The corresponding SDT is then created with its parameters.
The following SDTs can be used.
●
TCON_Configured
For transferring frames via TCP
●
TCON_IP_V4
For transferring frames via TCP or UDP
●
TCON_IP_V4_SEC
For the secure transfer of frames via TCP
●
TCON_QDN
For transferring frames via TCP or UDP (IPv4 / IPv6)
●
TCON_QDN_SEC
For the secure transfer of frames via TCP (IPv4 / IPv6)
●
TCON_IP_RFC
For transferring frames via ISO-on-TCP
●
TCON_ISOnative
For transferring frames via ISO transport
●
TMail_V4
For transferring e-mails addressing the e-mail server using an IPv4 address
●
TMail_V6
For transferring e-mails addressing the e-mail server using an IPv6 address
●
TMail_FQDN
For transferring e-mails addressing the e-mail server using the host name
●
TMail_V4_SEC
For secure transfer of e-mails addressing the e-mail server using an IPv4 address
●
TMail_V6_SEC
For secure transfer of e-mails addressing the e-mail server using an IPv6 address
●
TMail_QDN_SEC
For secure transfer of e-mails addressing the e-mail server using the host name
You will find the description of the SDTs with their parameters in the STEP 7 information
system under the relevant name of the SDT.
You can find a description of the parameters of SDTs TMail_V4_SEC, TMail_V6_SEC and
TMail_QDN_SEC in the online help section on TCON_IP_V4_SEC.
To Next Page
Loading...
Need help?
General
