Diagnostics and upkeep
5.3 Diagnostics with SNMP
CP 1543-1
74 Operating Instructions, 12/2019, C79000-G8976-C289-08
Supported MIBs in SNMPv1
The CP supports the following MIBs:
●
MIB II (acc. to RFC1213)
The CP supports the following groups of MIB objects:
– System
– Interfaces
– IP
– ICMP
– TCP
– UDP
– SNMP
●
LLDP MIB
●
Siemens Automation MIB
Note the rights for writing to the MIB objects, see the next section (SNMPv3).
Supported MIB objects in SNMPv3
If SNMPv3 is enabled, the CP returns the contents of the following MIB objects:
●
MIB II (acc. to RFC1213)
The CP supports the following groups of MIB objects:
– System
– Interfaces
The "Interfaces" MIB object provides status information about the CP interfaces.
– IP (IPv4/IPv6)
– ICMP
– TCP
– UDP
– SNMP
The following groups of the standard MIB II are not supported:
– Adress Translation (AT)
– EGP
– Transmission
To Next Page
Loading...
