2-2
PP7,
PP17-I, PP17-II Equipment Manual
Release 06/98
The
system settings for the DP connection are:
DP slave address:
3
Baud rate:
1500 KBaud
The following table provides an overview of the possibilities for modifying the
defined system settings:
Intention Procedure Chap-
ters
Set connection type DP Set connection type DP on the
Push Button Panel
2.1
Change DP slave address
Change the DP slave address
on the Push Button Panel
2.1
Change baud rate Change baud rate on Push
Button Panel
2.1
Configure Push Button Panel
properties which deviate from
Set parameter in the configu
-
2.3
propert
es w
c
ev
ate
rom
pre-adjusted system settings
rat
on so
tware
DP connection
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/
To Next Page
Loading...
Need help?
General
