2-5
PP7,
PP17-I, PP17-II Equipment Manual
Release 06/98
Refer
to the following table for the significance of the various menu items:
Name Explanation
DEFAULT
Used to select whether all the parameters should be reset
to the predefined system settings values.
CONNECTION
DP/MPI
Used to select the system connection type. Either MPI or
PROFIBUS-DP.
SLAVE-ADR
Defines the slave address of the Push Button Panel in
the PROFIBUS-DP system.
PP-MPI-ADR
Defines the MPI address of the Push Button Panel.
BAUDRATE
Defines the baud rate for data transmission using con
-
nection type MPI or PROFIBUS-DP in KBaud.
DAT
A MB/DB
Used to select whether the data area for the Push Button
Panel is created as a Memory Byte (MB) or Data Block
(DB).
MW
Defines the number of the first, reserved memory word
for the Push Button Panel.
DB
Defines the number of the data block in which the data
area for the Push Button Panel is reserved.
DW
Defines the number of the first, reserved data word for
the Push Button Panel in the data block.
PARAM.-DB
Defines the number of the configuring data block.
PLC-ADR
Defines the address of the PLC to which the Push But
-
ton Panel is connected.
PLC-TYPE
2/3/400
Used to select the type of PLC to which the Push Button
Panel is connected.
RACK-NO
Defines the number of the rack in which the PLC is
installed.
SLOT-NO
Defines the number of the slot within the rack.
HSA
Defines the highest station address within the MPI sys
-
tem.
NUMBER OF
MPI-MASTER
Defines the number of the MPI master in the system.
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/
To Next Page
Loading...
Need help?
General
