Need help?Do you have a question about the Siemens SIMATIC S7-CPs and is the answer not in the manual?
General| Brand | Siemens |
|---|---|
| Model | SIMATIC S7-CPs |
| Category | Network Router |
| Language | English |
Describes the CP's intended use, integrated switch, and port features.
Lists the communication services supported by the CP, such as PROFINET IO and S7 communication.
Describes the required STEP 7 version for full CP functionality.
Explains the use of pre-programmed blocks (FCs/FBs) for communication services.
Outlines the step-by-step process for installing the CP into the rack and connecting it.
Lists important characteristics of the SEND/RECEIVE interface, like connection counts and data lengths.
Lists important characteristics of the SEND/RECEIVE interface, like connection counts and data lengths.
Explains the limits on concurrent SEND/RECEIVE calls.
Details PROFINET IO capabilities as a controller, including device limits and data areas.
Details PROFINET IO capabilities as a controller, including device limits and data areas.
Explains the two-level memory reset functions (clear/reset and factory settings).
Describes how to specify synchronization parameters for IRT communication.
Describes how to specify synchronization parameters for IRT communication.
Offers recommendations to avoid CPU overload in high communication scenarios.
Discusses security measures for IT interfaces and preventing unauthorized access.
Explains the PROFINET functionality for prioritized startup of IO devices.
Details changing call parameters on the FC call interface after job confirmation.
Details changing call parameters on the FC call interface after job confirmation.
Provides step-by-step instructions for loading new firmware onto the CP.
To Next Page