Mounting and connecting the HMI device
3.2 Mounting the device
TP700 Comfort Outdoor, TP1500 Comfort Outdoor
Compact Operating Instructions, 05/2016, A5E35956909-AC
19
The mounting depth of the devices is:
TP1500 Comfort Outdoor 77 mm
Mounting the device
Positions of the mounting clips
To achieve the degree of protection for the HMI device, the positions for the mounting clips
shown below must be adhered to.
The positions of the mounting clips are marked by stamps on the cutouts. Fit the mounting
clips in all the stamped cutouts.
The following table shows the type, number, and position of the mounting clips needed for
the respective HMI devices.
Position on the HMI device
TP700 Comfort Outdoor Aluminum
mounting clip
8
TP1500 Comfort Outdoor Steel
mounting clip
12
● All packaging components and protective films were removed from the HMI device.
● To install the HMI device, you need the mounting clips from the accessories kit.
● The mounting seal must be installed on the HMI device.
To Next Page
Loading...
